ⓓ -OU
nnection Terminal
e to earth the sensor-
ⓖ +SIG
ⓗ -SIG on Terminal
.0mV/V
um output value of sensor .)
. Turn it off when wiring(main power supply)
thick cable for GN(PE Terminal) to prevent it from having impulse voltage
T : Analog Ground Output Terminal (-) , GND
ⓔ +EXC : Sensor Supply Voltage + Co
ⓕ -EXC : Sensor Supply Voltage - Connection Terminal
[Sensor Shield Connection Terminal (Be sur
attached part and this terminal.)]
: Sensor Output Signal + Connection Terminal
: Sensor Output Signal - Connecti
ⓘ Amplification Adjustment Switch
SW1 : 3.0mV/V SW2 : 2.0mV/V
SW3 : 1.5mV/V SW4 : 1
(Set with the number which gets near to maxim
◀Caution▶
1
2. Please use
and trouble resulting from surge.
3. Make sure the function of terminal belows and connect required contact input and
output.
4. Operation of internal Circuit
discretion.
makes possible for 110V conversion but do not operate
at one's
EXC+
EXC-
SIG+
SIG-
GND
IND L/C
7
To Next Page
Loading...