TYRE PRESSURE LOSS WARNING
3
186 - Driving
Possible messages
The table below shows the possible messages related to the tyre resetting procedure.
Steps Messages Readings
- Tyre pressure
init. at stop
The message is displayed during driving. If you want to reset the pressure of the four tyres, stop the
vehicle.
1 Tyre pressure
init. long press
To reset the pressure of the four tyres, with the vehicle stationary, press and hold the
6
"OK" switch
to launch resetting until the "If pressure OK [hold on]|" message is displayed.
2 If pressure OK
[hold on]
The message flashes to indicate that the system has registered the resetting procedure. If all four
tyres have been correctly adjusted to match the tyre pressure values recommended on the tyre
pressure label🡺327, press and hold the
6
"OK" switch until the "Operation completed" message
appears.
3 Operationcom
pleted
The resetting procedure has been completed successfully. You can now drive.
To Next Page
Loading...
