SPEED LIMITER
3
Driving - 235
Please note that you
must keep your feet
closetothepedalsinor
dertoreactinanemer
gency.
Varying the limit speed
The limit speed may be changed by
pressing repeatedly or holding down:
– switch
1
( SET/+ ) to increase the
speed;
– switch
6
( SET/˗ ) to decrease the
speed.
Thespeedlimiterfunc
tion is in no way linked to
the braking system.
Exceeding the limit speed
It is possible to exceed the limit speed
at any moment. To do this, press the
accelerator pedal firmly down beyond
the point of resistance.
While the speed is being exceeded,
the programmed speed displayed on
the instrument panel flashes.
Then, release the accelerator pedal:
the speed limiter function will return as
soon as you reach a speed lower than
the memorised speed.
Limited speed cannot be maintained
When driving down a steep gradient,
the system is unable to maintain the
limited speed: the stored speed will
flash in red on the instrument panel
and a beep sounds at regular intervals
to inform you of this situation.
If the speed limiter is not
available (after several
attempts to activate),
contact an approved
dealer.
Putting the function on standby
Thespeedlimiterfunctionissuspend
ed when you press switch
4
(O). The
limit speed is stored and displayed in
grey on the instrument panel.
Recalling the limit speed
If a speed has been stored, it can be
recalled by pressing the switch
5
.
When the speed limiter is
on standby, press switch
6
( SET/˗ ) or switch
1
( SET/
+ )toreactivatethefunctionwith
out taking into account the stored
speed: the vehicle's current speed
will be taken into account instead.