4–10 FRONT
13.Apply the sealer
• Apply the sealer to the matching and overlapped
surface.
14.Apply the undercoat.
• Undercoat to the inside of the front, rear wheel-
house and longitudinal.
15.Apply the paint.
CAUTION
• Ventilate when spraying paint. Most paint contains
substances that are harmful if inhaled or swal-
lowed.
Read the paint label before opening paint con-
tainer.
• Avoid contact with skin. Wear an approved res-
pirator, gloves, eye protection and appropriate
clothing when panting.
• Paint is flammable. Store in a safe place, and
keep it away from sparks, flames or cigarettes.
16.Coating the anti-rust agents.
• Coating the anti-rust agents to the end of front
panel side and the door hinge areas.
17.Install the related parts.
• Wiring harness, instrument panel and related
parts.
• Parts of the passenger compartment.
• Parts to be installed when install the front panel.
• Others.
• Install in the reverse order in which they were re-
moved.
NOTE: After install the all related parts, rub in grease
to the moving parts and replenish cooling liquid,
break oil, aircon gas and others.
18.Check and adjust
• Measure the front wheel alignment.
• Check clearances and level differences.
• Check the hood locking and unlocking condition.
• Adjust the head lamp aim.
• Check all operation.
• Check for gas, oil and liquid leaks.
NOTE: Use specified check sheet for operation check
properly.
To Next Page
Loading...
