ROOF, BACK PANEL AND REAR FLOOR PANEL 5–5
10.Apply the sealer.
• Apply the sealer to the welded areas.
Fig. 7
11.Apply the paint.
CAUTION
• Ventilate when spraying paint. Most paint contains
substances that are harmful if inhaled or swal-
lowed.
Read the paint label before opening paint con-
tainer.
• Avoid contact with skin. Wear an approved respi-
rator, gloves, eye protection and appropriate cloth-
ing when painting.
• Paint is flammable. Store in a safe place, and keep
it away from sparks, flames or cigarettes.
12.Apply the deadner.
• Apply the deadner to the front inside of roof panel
as shown.
9. Perform the main welding and finish.
• Spot weld the roof panel.
CAUTION: To prevent eye injury and burns when
welding, wear an approved welding helmet, gloves and
safety shoes.
• Perform a trial welding first, and check the weld-
ing condition.
• Increase the number of spot by 20% for areas to
be spot welded.
• Use a hammer and dolly to smooth the spot weld
areas on the windshield and rear glass.
• Cut off the irregular and unuseful flanges and
even out the flanges for a close fit with the sur-
face of the roof panel.
Fig. 6
To Next Page
Loading...
