- 14 -
7. TRANSPORT AND INSTALLATION (continued)
7.2 Installation (continued)
CAUTION
To prevent electromagnetic troubles, read the following.
Also, if electromagnetic troubles occur, check the following again.
٨
Change the installation place of the welding machine.
٨
Mount an input cable in the grounded metallic conduit.
٨
Provide electromagnetic shield to the whole welding places.
CAUTION
Follow the instructions below when selecting an installation place of the welding power
source.
٨Do not put heavy things on the welding machine.
٨Do not cover the ventilation port of the welding machine.
٨Do not install the welding power source in the place subject to direct sunlight or rain.
٨Do not place the welding power source, wire feeder, torch, control unit, conduit and
control cable (including the extension cable) in an area where the equipment can become
wet. Place the welding machine on a strong and stable surface.
٨Install the welding machine in the place where the ambient temperature is between -10 ˚C
and +40 ˚C (+14 ˚F and +104 ˚F).
٨Do not install the welding machine in the place where metal material such as spatter
enters the welding power source.
٨Keep the install distance of 30 cm between the welding power source and the wall or other
welding power source.
٨Install a wind shield to protect arc from wind.
٨
Fix the gas cylinder to the stand specifically made for gas cylinder.
HF
To Next Page
Loading...