Dahen DA300P - Front Panel; Operation

- 27 -
10. OPERATION
Front panel
[19][18] [17] [3] [11] [13]

[14]

[3] [4] [6] [7]
[16] [9] [5] [10] [2] [12] [1] [15] [8]
[1] WELDING METHOD change-over key [9] ARC SPOT TIME setting key [17] LOAD key
[2] AC WAVE change-over key [10] Function selection key [18] SAVE key
[3] Parameter selection key [11] INITIAL CURR. selection key [19] ENTER key
[4] Parameter adjusting knob [12] PULSE selection key
[5] CRATER FILL. key [13] LIFT START key
[6] AC FREQ. key [14] SLOPE selection key
[7] AC BALANCE key [15] TORCH change-over key
[8] AC-DC change-over frequency set up key [16] GAS CHECK key
㧲
t
f
CRATER
㧙
FILL.
SPOT TIME
GAS
CHECK
OFF
ON
REPEAT
SPOT
WELDI NG
METHOD
ON ON ON ON WATER
TORCH
SLOPE
INIT IAL
CURR.
PULSE
LIFT
START
LOAD
SAVE
ENTER
ASec
Hz
%
JOB
MEMORY
JOB NO.
AC- TIG
DC- STI CK
AC- DC TI G
DC- TIG
PULSE CURR.
㧔
BASE CURR.
㧕
PULSE FREQ.
UP SLOPE
DOWN SLOPE
I NITI AL CURR. CRATER- FILL.
CURR.
WELDING CURR.
㧭㧯
WAVE
㧭㧯
FREQ.
AC- DC
FREQ.
STANDARD
SOFT
HARD
DC NO- LOAD VOLTAGEWARNI NG
T1 T2
AC BALANCE
