- 13 -
7. TRANSPORT AND INSTALLATION
7.1 Transport
WARNING
To prevent accidents and damage of the welding machine during transportation, observe the
following.
٨Do not touch the live electrical parts inside or outside the welding machine.
٨Be sure to disconnect the line disconnect switch when carrying the welding
machine.
٨When hanging the welding power source by a crane, cover the power
source with the cover or the case and tighten eye-bolts.
٨Lift one welding power source with two wires. Lifting the welding power
source and other equipment together may cause them to drop.
٨When carrying the welding machine with a fork lift, etc., securely make
scotch-block.
٨When hanging the welding power source by a crane, do not use the carrying
handle.
7.2 Installation
WARNING
When installing the welding machine, follow the instructions below to avoid a fire caused by
welding or physical injury from gas fumes.
٨Do not place the welding machine near combustible materials or flammable
gas.
٨Remove combustible materials to prevent dross coming into contact with
combustible objects. If that is not possible, cover them with
noncombustible covers.
٨
To avoid gas poisoning and danger of suffocation, wear a gas mask or
adequately ventilate when the welding machine is used in the place
regulated by local law.
٨
To prevent injury or poisoning caused by fume, wear a gas mask or weld at
a partial exhaust facility approved by the local regulation.
٨
Adequately ventilate or wear a gas mask when using the welding machine
in a tank, in a boiler or in a hold of a ship, because heavier gasses such as
carbon dioxide or argon gases are settle there.
٨
When using the welding machine at a narrow space, comply with a trained
supervisor’s directions. And be sure to wear a gas mask or adequately
ventilate.
To Next Page
Loading...