103
3.11.1.10 Alarm Centre
This interface is reserved for you to develop. See Figure 3-107.
Figure 3-107
3.11.1.11 Auto register
This function allows the device to auto register to the proxy you specified. In this way, you can use the
client-end to access the NVR and etc via the proxy. Here the proxy has a switch function. In the network
service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the auto
register function, the device can auto register to the proxy server.
1) The setup interface is shown as in Figure 3-108.
Important
Do not input network default port such as TCP port number.
To Next Page
Loading...
Need help?
General
