148
Please refer to the following sheet for detailed information.
It is the max Web connection for the same device. The value
ranges from 1 to 120. The default setup is 120.
The default value is 37777. You can input the actual port
number if necessary.
The default value is 37778. You can input the actual port
number if necessary.
The default value is 80. You can input the actual port number if
necessary.
The default value is 443. You can input the actual port number if
necessary.
The default value is 554.
4.8.2.3 PPPoE
From main window->Setup->Network->PPPoE, the PPPoE interface is shown as in Figure 4-28.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the
IP address column.
Please note, you need to use previous IP address in the LAN to login the device. Please go to the
IP address item to via the device current device information. You can access the client-end via
this new address.
Figure 4-28
4.8.2.4 DDNS
From main window->Setup->Network->DDNS, the DDNS interface is shown as in Figure 4-29.
The DDNS is to set to connect the various servers so that you can access the system via the server.
Please go to the corresponding service website to apply a domain name and then access the system via
the domain. It works even your IP address has changed.
Please select DDNS from the dropdown list (Multiple choices). Before you use this function, please make
sure your purchased device support current function.
To Next Page
Loading...
Need help?
General
