Dahua 6064 SERIES

59
3.7.4.2 Alarm Snapshot
a) Please refer to Step a) to step c) of chapter 3.7.3.2 to enable timing snapshot.
b) From Main menu->Setting->Storage->schedule, you can go to Figure 3-57 to enable snapshot
function.
c) From Main menu->Setting->Event->Alarm, you can go to Figure 3-56 to set alarm parameter
and enable snapshot function.
d) Click Save button to save alarm snapshot setup.
Figure 3-57
3.7.5 Manual Record/Snapshot
You need to have proper rights to implement the following operations. Please make sure the HDD
has been properly installed.
3.7.5.1 Manual Record
a) Right click mouse and select manual record or in the main menu, from
Setting->Storage->Manual Record. Manual record menu is shown as in Figure 3-58.
Tips
You can click Rec button on the front panel (if possible) to go to the Manual Record interface.