Figure 4-123
Select SN (object1/2/3/4) and direction, and then input customized rule name.
Object1/2/3/4: System supports four zones. Each SN stands for one zone.
Direction ( / ): For icon , system can generate an alarm once the
object left in the one for the specified time. For icon , system can generate an
alarm once the object is out of the zone for the specified time.
Period: It refers to the object in/out the zone time.
Now you can draw a rule. Left click mouse to draw a line, until you draw a rectangle, you
can right click mouse.
Click Ok to complete the rule setup.
Tips
Click to delete the corresponding rule.
You can refer to the chapter 4.11.3.2.1 to set parameters.
4.11.3.3 Face Detect (Optional)
The face detection function is optional. The intelligence function and the
human face detection can not be valid at the same time!
Note
The face detection function is valid once your network camera or your DVR supports
this function.
If your purchased DVR supports the face detection function, it supports one analog
channel. It is not for the digital channel.
System can detect and filter the human face via analyzing the video. When it detects
the human face in the specified zone, it can draw the rectangle around the human face
To Next Page
Loading...
