Figure 5-24
5.8.1.4 Channel Name
Here you can set channel name. See Figure 5-25.
Please note this function is for analog channel only. The digital channel name here is
read-only.
Figure 5-25
5.8.1.5 Channel Type
It is to set channel type. Each channel supports analog camera（analog standard
definition/HDCVI） /network camera connection. Please note DVR needs to restart to
activate new setup. The network camera connection shall begin with the last channel. For
the 16-channel (or higher) series product, please go to the next page to set. See Figure
5-26.
Important notice about XVR series product:
Nowadays, there are mainly two analog signal types on today market: analog
standard definition (CVBS) and analog HD (CVI, AHD or Other). For XVR series
product, each channel supports all types of signal connection (analog signal/IP
signal). For analog signal connection, the default setup is AUTO, that is to say, no
matter what analog signal (CVBS, CVI, AHD or other analog HD signal) connected;
the XVR can automatically recognize the signal and display the proper image. There
is no need to set manually.
If the auto recognition error occurred, XVR series product supports manual setup too.
The manual setup featuring high recognition speed and usually there is no error. For
example, you can set channel 1 to connect to CVI camera, channel 2 to connect to
AHD camera, channel 3 to connect to CVBS camera.
To Next Page
Loading...
Need help?
General