Advanced Settings 10
1) Click Add Interface.
A new record is added. See Figure 4-3.
VLAN interface
Figure 4-3
2) Set the parameters. See Table 4-1.
Table 4-1 VLAN interface
Set the IP address of the VLAN interface.
Set the mask length of the IP address.
Add IP route. Step 3
1) Click Add Route.
A new record is added. See Figure 4-4.
IP routes Figure 4-4
2) Set the parameters. See Table 4-2.
Table 4-2 IP routes
It is the destination address of the IP packet.
Mask length, with destination address, is to identify the IP address of
the destination host or the route. After logical AND between
destination address and network mask, you can get the IP address of
the destination host or the route.
The gateway IP address of the route.
Click Save. Step 4
4.1.1.3 NTP
Enable NTP function, and the switch can synchronize with the network time automatically.ć
Select Advanced > Configuration > System > NTP. Step 1
NTP Configure interface is displayed. See Figure 4-5.
To Next Page
Loading...
