Advanced Settings 11
NTP configuration (1) Figure 4-5
Select the mode as Enabled to enable the NTP service. By default, the mode is Step 2
Disabled.
Set the IP address of the NTP server. See Figure 4-6. Step 3
NTP configuration (2) Figure 4-6
Click Save. Step 4
The switch can synchronize with the time of server 1.
4.1.1.4 Time
You can set the time zone and daylight saving time.
Select Advanced > Configuration > System > Time. The Time settings interface is displayed.
See Figure 4-7.
To Next Page
Loading...
