Dahua PFS4218-16GT-190 - Page 32

Advanced Settings 25
Click Add New Entry. Step 2
A new record is added. See Figure 4-31.
Add a user.
Figure 4-31
Set the parameters. See Table 4-7. Step 3
Table 4-7 User parameter
Parameter
Description
Engine ID
It is created automatically.
User Name
Input the user name.
Security Level
Select the security level from the drop-down list.
If you select “Auth, Priv”, you need to set the Authentication

Protocol and the Authentication Password, Private Protocol
and the Private Password.
If you select “NoAuth, NoPriv”, you do not need to set the

protocol and password.
If you select “Auth, NoPriv”, you need to set the

Authentication Protocol and the Authentication Password.
Click Save. Step 4
Groups
After SNMP group configured, you can add the SNMP user to the SNMP group when
configuring SNMP user. You can manage the users in the group better through managing the
group.
Select Advanced > Configuration > Security > SNMP > Groups. Step 1
The Groups interface is displayed. See Figure 4-32.
Groups Figure 4-32
Click Add New Entry. Step 2
A new record is added. See Figure 4-33.