Dahua PFS4218-16GT-190 - Page 33

Advanced Settings 26
Add a group Figure 4-33
Set the parameters. See Table 4-8. Step 3
Table 4-8 Group parameter
Parameter
Description
Security Mode
Select the security mode from the drop-down list, including v1, v2c,
and usm.
Security Name
Select the security name from the drop-down list.
Group Name
Input the group name.
Click Save. Step 4
Views
After SNMP views configured, you can specify the SNMP views for the SNMP group to limit the
MIB target that the SNMP group can visit.
Select Advanced > Configuration > Security > SNMP > Views. Step 1
The Views interface is displayed. See Figure 4-34.
Views Figure 4-34
Click Add New Entry. Step 2
A new record is added. See Figure 4-35.
Add a new view Figure 4-35
Set the parameters. See Table 4-9. Step 3
Table 4-9 Views parameter
Parameter
Description
View Name
Input the view name.