Advanced Settings 38
Click Add New Entry. Step 2
A new record is added. See Figure 4-53.
Add a new static table
Figure 4-53
Set the parameters including Port, VLAN ID, MAC Address, and IP Address. Step 3
Click Save. Step 4
Dynamic Table
Dynamic table is automatically created and maintained by ARP through ARP packet. It can be
aging, and it can be covered by new ARP packet or static ARP table. When reaching ageing
and the port is down, the corresponding dynamic table will be deleted.
Select Advanced > Configuration > Security > ARP Inspection > Dynamic Table. The
Dynamic Table interface is displayed. See Figure 4-54.
Dynamic table Figure 4-54
4.1.4.9 802.1X
Nas
Select Advanced > Configuration > Security > 802.1X. Step 1
The Nas interface is displayed. See Figure 4-55.
To Next Page
Loading...
