5 Configuration
Confirm that all devices are complete and that they work properly prior to installation and
configuration.
Setup
Prior to commissioning and configuring the VTO unit, ensure the unit conforms to the following:
Check that the unit is connected to the proper power supply. Power on the device only
after the circuit is confirmed to be normal.
Plan the list of IP Addresses and the ID numbers for each VTO and VTH unit.
Check the deployment position of SIP server.
Use the VTO Web interface to set VTO and VTH information. Then set the VTH and VTO
information at each VTH device.
Process
Plan IP address for every device, and also plan the unit number and room number you
need.
Configure VTO. See "4.3 Configuring VTO."
a) Initialize VTO.
b) Configure VTO number.
c) Configure VTO network parameters.
d) Configure SIP Server.
e) Configure target room number and group call.
f) Add VTO devices to the SIP server.
g) Add room number to the SIP server.
Configure VTH. See the VTH users' manual.
Verify Configuration.
VDP Configuration
Download the "VDPConfig" application and perform the device initialization, IP address
modification, and system upgrading for multiple devices at the same time.
VTO Configuration
Connect the VTO to your PC with network cable, and for first time login, you need to create a
new password for the web interface.
To Next Page
Loading...
Need help?
General
