Dahua VTO Series User Manual

In the VTO No. input box, enter the VTO number you planned for this VTO, and then click
Confirm to save.
5.4.3 Configuring Network Parameters
Select Network Setting > Basic.
Enter the network parameters you planed, and then click Save.
The VTO will reboot, and you need to modify the IP address of your PC to the same
network segment as the VTO to log in again.
5.4.4 Configure SIP Server
The SIP server is required in the network to transmit intercom protocol, and then all the VTO
and VTH devices connected to the same SIP server can make video call between each other.
You can use VTO device or other servers as SIP server. Press and hold Setting until the
system displays the Password Verification dialog box.
Select Network Setting > SIP Server.
Select the server type you need.
 If the VTO you are visiting works as SIP server:
Select the Enable check box at SIP Server, and then click Save.
The VTO will reboot, and after rebooting, you can then add VTO and VTH devices to
this VTO.
 If the VTO you are visiting does not work as SIP server, do not select the Enable check
box at SIP Server, otherwise the connection will fail:
If other VTO works as SIP server. select VTO in the Server Type list, and then
configure the parameters

Dahua VTO Series Specifications

General

Category	Intercom System
Dimensions	Varies by model
Weight	Varies by model
Model	VTO Series (multiple models exist within the series)
Video Resolution	1080p, 720p (depends on model)
Audio	Two-way audio communication
Network Interface	Ethernet (some models support Wi-Fi)
Power Supply	12V DC or PoE (Power over Ethernet), Varies by model
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Weatherproof	IP65
Supported Protocols	SIP