Daikin Altherma ERGA04E V3 Series - Configuration Wizard

10 | Configuration
Installer reference guide
142
ERGA04~08E + EHVH04+08SU18+23E
Daikin Altherma 3 R F
4P629090-1C – 2022.08
10.2 Configuration wizard
After first power ON of the system, the user interface starts a configuration wizard.
Use this wizard to set the most important initial settings for the unit to run
properly. If required, you can afterwards configure more settings. You can change
all these settings via the menu structure.
You can find a short overview of the settings in the configuration here. All the
settings can also be adjusted in the settings menu (use the breadcrumbs).
For the setting… Refer to…
Language [7.1]
Time/date [7.2]
Hours —
Minutes
Year
Month
Day
System
Indoor unit type (read only) "10.6.9Installer settings"[4206]
Backup heater type [9.3.1]
Domestic hot water [9.2.1]
Emergency [9.5.1]
Number of zones [4.4] "10.6.5Space heating/
cooling"[4183]
Backup heater
Voltage [9.3.2] "Backup heater"[4208]
Configuration [9.3.3]
Capacity step 1 [9.3.4]
Additional capacity step 2
[9.3.5] (if applicable)
Main zone
Emitter type [2.7] "10.6.3Main zone"[4168]
Control [2.9]
Setpoint mode [2.4]
Heating WD curve [2.5] (if
applicable)
Cooling WD curve [2.6] (if
applicable)
Schedule [2.1]
Additional zone (only if [4.4]=1)