Daikin Altherma ERGA04E V3 Series - Commissioning; User Profile

10 | Configuration
Installer reference guide
226
ERGA04~08E + EHVH04+08SU18+23E
Daikin Altherma 3 R F
4P629090-1C – 2022.08
Export MMI settings
About exporting the configuration settings
Export the configuration settings of the unit to a USB memory stick, via the MMI
(the user interface of the indoor unit). When troubleshooting, these settings can
be provided to our Service department.
# Code Description
[9.N] N/A Your MMI settings will be exported
to the connected storage device:
▪ Back
▪ OK
To export MMI settings
1 Open the user interface panel and insert a USB memory stick.
2
1
1
—
2 On the user interface, go to [9.N] Export MMI settings.
3 Select OK.
4 Remove the USB memory stick and close the user interface
panel.
—
10.6.10 Commissioning
Overview
The following items are listed in the submenu:
A
Commissioning
User profile
Installer settings
Information
Operation
[A] Commissioning
[A.1] Operation test run
[A.2] Actuator test run
[A.3] Air purge
[A.4] UFH screed dryout
About commissioning
See: "11Commissioning"[4232]
10.6.11 User profile
[B] User profile: See "To change the user permission level"[4139].