Daikin Altherma ERGA04E V3 Series - Page 228

10 | Configuration
Installer reference guide
228
ERGA04~08E + EHVH04+08SU18+23E
Daikin Altherma 3 R F
4P629090-1C – 2022.08
This needs the following components in case of WLAN cartridge:
b
a
c
This needs the following components in case of WLAN module:
a b c
a WLAN cartridge The WLAN cartridge needs to be inserted in the
user interface. See the installation manual of the
WLAN cartridge.
WLAN module The WLAN module needs to be installed by the
installer on the indoor unit (on the inside of the
front panel). See:
▪ Installation manual of the WLAN module
▪ Addendum book for optional equipment
b Router Field supply.
c Smartphone + app The ONECTA app needs to be installed on the
user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Configuration
To configure the ONECTA app, follow the in-app instructions. While doing this, the
following actions and information are needed on the user interface:
Mode: Turn AP mode ON (=WLAN cartridge/module active as access point) or OFF.
# Code Description
[D.1] N/A Enable AP mode:
▪ No
▪ Yes
Reboot: Reboot the WLAN cartridge/module.