Daikin BRC2E52C - Page 9

BRC2E52C7 / BRC3E52C7 Operation manual
4P368042-1 - 2014.02
8
Names and Functions
1. Operation Mode Selector button
• Only available on the BRC2E
• Press this button to select the operation
mode of your preference. (See "Cool/Heat/
Auto/Fan Operation" on page 13)
• Available modes may vary with the
connected model.
2. Fan Speed button
• Used to change the fan speed. (See "Cool/
Heat/Auto/Fan Operation" on page 13)
• Available fan speeds may vary with the
connected model.
3. Menu/Enter button
• This button is disabled by default.
To enable, refer to "Enable/disable the
Menu/Enter and Cancel button" on
page 12.
• Used to display the Main Menu or enter the
selected item (See "The Main Menu Items
Overview." on page 23).
4. Up button
• Used to raise the set temperature.
• The next item on the upper side will be
highlighted.
(Keep pressing the button to cycle through
the values or items).
• Used to change the selected item.
5. Down button
• Used to lower the set temperature.
• The next item on the lower side will be
highlighted.
(Keep pressing the button to cycle through
the values or items).
• Used to change the selected item.
6. Right button
• Used to highlight the next items on the
right-hand side.
• The display contents are changed to the
next screen.
7. Left button
• Used to highlight the next items on the
left-hand side.
• The display contents are changed to the
previous screen.
8. ON/OFF button
• Press to start or stop the air conditioner.
9. Operation lamp (Green)
• This lamp lights up during operation.
• This lamp is not lit when the unit operation
is OFF.
• This lamp blinks if an error occurs.
10. Cancel button
• This button is disabled by default.
To enable, refer to "Enable/disable the
Menu/Enter and Cancel button" on
page 12.
• Used to return to the previous screen.
11. LCD (with backlight)
• The backlight will be lit for approximately
30 seconds when one of the buttons is
pressed.
• The actions linked to the buttons , except
for the ON/OFF button, are not carried out
when the backlight is not lit.
• When two remote controllers are used to
control a single indoor unit, the backlight of
the remote controller which is operated rst
will be lit.