EasyManua.ls Logo

Daikin DGE601A52 - Page 5

Daikin DGE601A52
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Manual 3P581074-2D
DGE601A52
3English
CAUTION
Be very careful when transporting the unit.
Safely dispose of the packing materials.
Tear apart and throw away plastic packaging bags so that children will not play with them.
If children play with a plastic bag which was not torn apart, they face the risk of suffocation.
This unit is a class B product.
In a domestic environment, this product may cause radio interference.
In such cases, the user may be required to take adequate measures.
Disposal requirements: the dismantling of the unit and of other parts must be done in
accordance with relevant local and national legislation.
Fill wiring intake hole with putty.
Entry of water or insects may result in electric leakage or malfunction.
Do not operate with wet hands.
An electric shock and malfunction may be caused.
Do not wash the unit with water.
An electric shock or re may be caused.
Install the unit, its power cord, and its wiring at least 1m away from televisions or
radios.
This is to prevent picture interference and noise. (Depending on the incoming signal
strength, a distance of 1m may not be sufcient to eliminate noise.)
Do not install the unit in the following places.
1.
In places with a high concentration of mineral oil spray or vapour (e.g. a kitchen).
Plastic parts will deteriorate, parts may fall off and water leakage could result.
2. Near machinery emitting electromagnetic radiation.
Electromagnetic radiation may disturb the operation of the control system and result in a
malfunction of the unit.
3. In places where ammable gas may leak, where there is carbon bre or ignitable dust
suspensions in the air, or where volatile ammables such as paint thinner or gaso-
line are handled.
Operating the unit in such places may result in re.
4. In places with high temperatures or where the unit is exposed to direct ames.
Abnormal heat build-up or ring may be caused.
5. In moist areas or places that are exposed to water.
Water entering the unit may cause electric shock and malfunction.
01_EN_3P581074-2D.indd 3 2021/06/25 14:12:08

Table of Contents

Related product manuals