70 Installation Manual 3P581074-2D
DGE601A52
English
4.3 Setting address on the outdoor unit
Setup on the outdoor unit
To use the DGE601A51, you need to set an Airnet address for the outdoor unit.
Also, you need to set a demand address and enable demand setting if necessary.
To set the address of an outdoor unit, you can use the push buttons located on the unit’s
printed circuit board.
The current setting or operating status of an outdoor unit is indicated by the outdoor
unit’s LED or segment display.
For details, refer to the service manual of the air conditioner.
<LEDs (segment) and setting switches for each mode>
Display of each mode
setting switch
Display of each mode
(LED/Segment)
Outdoor unit with LED display
Outdoor unit with
segment display
Lit
Unlit
01_EN_3P581074-2D.indd 70 2021/06/25 14:12:20
To Next Page
Loading...
