ESIE15-13B Wireless Remote Controller
Remote Controller 19
2.3 MAIN/SUB Setting
Introduction
To set the wireless remote controller, you have to set the address for:
The receiver of the wireless remote controller
The wireless remote controller.
Setting the Address for the Receiver
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller
should be set to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
MAIN/SUB MAIN SUB
MAIN/SUB
switch (SS1)
To Next Page
Loading...
