Daikin FTXS36HVJU - Page 144

SiUS04-924_A Indoor Unit
136 Removal Procedure
2
Remove the sensor
from the shield plate.
 When reassembling, set the
sensor at the position where it
“clicks”. Otherwise, the sensor is
not completely set.
3
Remove the shield
plate by unfastening the
2 hooks.
4
Disconnect the
connector.
[S36]: control PCB
Step
Procedure Points
(R9525)
Sensor Shield plate
(R9526)
Shield plate (rear)
Hook
INTELLIGENT EYE
sensor PCB
(R9527)
[S36]