Daikin FTXS36HVJU - Forced Cooling Operation

Forced Cooling Operation SiUS04-924_A
Trial Operation and Field Settings 183
2. Forced Cooling Operation
Indoor Unit
Outdoor Unit
Item Forced Cooling
Conditions The forced cooling operation is allowed when both the following conditions are
met.
1) The outdoor unit is not abnormal and not in the 3-minute standby mode.
2) The outdoor unit is not operating.
Start The forced cooling operation starts when any of the following conditions is
fulfilled.
1) Press the forced cooling operation ON/OFF button (SW1) on the indoor unit
for 5 seconds.
2) Press the forced cooling operation ON/OFF button (SW1) on the outdoor
unit.
Command
frequency
55 Hz
End The forced cooling operation ends when any of the following conditions is
fulfilled.
1) The operation ends automatically after 15 minutes.
2) Press the forced cooling operation ON/OFF button (SW1) on the indoor unit
again.
3) Press the ON/OFF button on the remote controller.
4) Press the forced cooling operation ON/OFF button (SW1) on the outdoor
unit.
Others The protection functions are prior to all others in the forced cooling operation.
ON/OFF button (SW1)
(R14145)
LED-A
SW4
ON
ABCD
S102
SW1
S2
Forced cooling
operation
ON/OFF button
(SW1)
(R14475)