Outdoor Unit SiUS04-924_A
Removal Procedure 167
4
Disconnect the
connector for fan motor
[S70] and release the 2
ferrite cores attached to
the electrical box with
clamps.
When reassembling, insert the
clamp into a small hole.
5
Release the fan motor
lead wire.
Fix the ferrite core at where the
tension does not pull the PCB
assembly when connecting the
connectors.
: When reassembling, do not use
these 2 hooks.
6
Disconnect the
connectors of the front
side.
[S20]: electronic expansion valve
coil
[S80]: four-way valve coil
[S90]: thermistors
Cooling only models have no
harness for [S80].
Step Procedure Points
(R9878)
Fixing position for the
ferrite core of
electronic expansion
valve coil
Fixing position for the ferrite
core of fan motor
(R14466)
Fan motor lead wire
To Next Page
Loading...
