Adjusting the 3-D airflow direction
To start 3-D airflow
To cancel 3-D airflow
COMFORT AIRFLOW operation
Notes on louvers and fins angles
ATTENTION
1. 3. Press the and the :
the " " and " " display will light up and the
louvers and fins will move in turn.
2. 4. Press either the or the .
• Check COMFORT AIRFLOW operation in the section of "COMFORT AIRFLOW Operation" and
"INTELLIGENT EYE Operation".
Page 14,15
NOTE
• When "SWING button" is selected, the louvers swinging range depends on the operation. (See
the figure.)
• Using three-dimensional airflow circulates cold air, which tends to collected at the bottom of the
room, and hot air, which tends to collect near the ceiling, throughout the room, preventing areas
of cold and hot developing.
Three-dimensional (3-D) airflow
• Always use a remote controller to adjust the angles of the louvers and fins. If you attempt to move
it forcibly with hand when it is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the fins angles. In side the air outlet, a fan is rotating at a
high speed.
COOL and DRY operation
HEAT operation
FAN operation
COMFORT AIRFLOW10˚
COMFORT AIRFLOW
Upper limit
Upper limit
Upper limit
15˚
15˚
50˚
Lower limit
Lower limit
Lower limit
Stop operation
Stop operation
Stop operation
30˚
70˚
70˚
75˚
To Next Page
Loading...
