Instructions SiBE01-503
42 System Configuration
15
■
To use ON TIMER operation
1. Press “ON TIMER button”.
•
The time changes in 1 hour increments
every time the button is pushed, with a maxi-
mum of 12 hours.
■
To cancel ON TIMER operation
2. Press “CANCEL button”.
•
The TIMER lamp goes off.
■
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
■
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
1
2
ON
OFF
The TIMER lamp
lights up.
Display
(Example)
The air conditioner is currently
operating. You want to have it run for
another hour, then stop for 7 hours,
then start up again.
To Next Page
Loading...
