Daikin Intelligent Touch Manager DCM601A71 - Outputting Function Settings

User’s Manual EM11A017
DCM601A71 intelligent Touch Manager
137
7-2 Outputting Function Settings
The iTM includes various functions, and each of them needs settings. You can output them to a
CSV file using the batch settings output function and load it to a computer to check the current
values in a list. The following describes how to output the settings.
See below for settings you can output using this function.
<Batch settings output details>
For information on how to interpret the output le, see the tables on the next pages.
Function Output content
Schedule Settings of programs registered with the Schedule Control.
Interlocking Control Settings of programs registered with the Interlocking Control.
Emergency Stop Settings of programs registered with the Emergency Stop.
Auto Changeover Settings of programs registered with the Auto Changeover.
Temperature Limit Settings of groups registered with the Temperature Limit.
Sliding Temperature Settings of groups registered with Sliding Temperature.
HMO Settings of management points registered with HMO.
Setback Recovery temperature and setback temperature settings.
Power Proportional
Distribution
Excluded time settings of the past 13 months.
1. Touch the Setup Export button on the Operation Mgmt. tab of the Menu List screen (see page
56).
2. A confirmation dialog with the message “Save CSV-file with batch output settings?” appears.
Connect a USB memory to the iTM unit and touch the Yes button. Outputting to the USB
memory takes up to 2 minutes per 1MB.
3. Output is complete when the message “File has been saved.” appears. Touch the Close button
to close the screen.