Daikin Intelligent Touch Manager DCM601A71 - Page 191

User’s Manual EM11A017
DCM601A71 intelligent Touch Manager
190
To add a management point, select one from (10) and touch the Add button. To remove a
management point, select one from (9) and touch the Remove button.
You can register up to 6 management points to monitor.
When nished, touch the OK button to save and return to the Emergency Stop Program Settings
screen.
(11)
(12)
(13) (14)
6. (11) is the list of management points target of the Emergency Stop. Touch the Modify button (12)
and register management points, as in step 5.
7. Using the Release Mode combo box (13), select the method of releasing the emergency stop
program from Automatic and Manual.
Using the Specication method combo box (14), select whether the the Output list (11) is the
list of emergency stop targets or the list of those excluded.
The management points, which was newly registered after creating the emergency stop
program, can be used as follows.
• On the program which uses the list (11) as the list of emergency stop targets, it cannot be
stopped emergently.
• On the program which uses the list (11) as the list of those excluded, it can be stopped
emergently.
NOTE
When nished, touch the OK button to save and return to the Emergency Stop Control screen.