User’s Manual EM11A017
DCM601A71 intelligent Touch Manager
193
The following describes how to set this up.
1. Touch the Temp. Limit button on the Automatic Ctrl. tab of the Menu List screen and display the
Temperature Limit screen (see page 52).
(1)
(2)
(3)
(4)
(5)
2. (1) is the list of Temperature Limit groups. Perform the intended operation by touching the
relevant button on the right.
(2) Create button
Creates a new group and displays the Name Setup dialog that allows you to enter the name.
Duplicate names are not permitted. You can create up to 8 Temperature Limit groups. Touch the
OK button to save and close the screen. The created group is added to the list.
(3) Delete button
Deletes the selected group.
(4) Registration button
Displays the Registration screen that allows you to registerdelete the selected management
point as member.
(5) Attributes button
Displays the Attribute screen that allows you to rename the selected group, set up the upper
limit/lower limit room temperatures, etc.
To Next Page
Loading...
