User’s Manual EM11A017
DCM601A71 intelligent Touch Manager
277
• Icon View in Each Status
Maintenance Stop/No operation Setback Inactive Setback Active Start (*1)
Icon
When all
management points
connected to the
iTM are in
maintenance
• When all
management
points connected
to the iTM are
Stop/No operation
• When no
management
point is connected
to the controller
When there is at
least one
management point
with inactive setback
When there is at
least one
management point
with active setback
When there is at
least one
management point
connected to the
iTM that is operating
*1
Communication
Error
Unit/Limit Error System Error Emergency Stop Network Error
Icon
When there is at
least one
management point
connected to the
iTM with
communication error
When there is at
least one
management point
connected to the
iTM with error
(Error sign is
displayed over the
Operating, Stop/No
operation)
When there is a
system error in iTM
*2
When there is at
least one
management point
connected to the
iTM in emergency
stop
• When there is
communication
error between the
iTM integrator and
iTM
• When two iTM
integrators are
connected to a
single iTM
• When the version
is not compatible
*1 The icon color is displayed in the color set up in the System Settings.
*2 An error of the proportional distribution system is judged as restored when the balloon has
disappeared.
• When the statuses of management points connected to the iTM vary, that with the highest
priority is displayed with an icon. The order of priority is as follows:
“Maintenance” < “Stop/No operation” < “Setback Inactive” < “Setback Active” < “Operating”
< “Communication Error” < “Unit/Limit Error” < “System error” < “Emergency Stop” <
“Network Error”
NOTE
To Next Page
Loading...
