User’s Manual EM11A017
DCM601A71 intelligent Touch Manager
45
• Dio, Ao Tab
Sets up the Dio and Ao.
Change settings by selecting the relevant check boxes.
(1)
(2)
(1) Dio
Enable/disable Repeat Mode for Dio, and select and set up a repetition interval in the 1 to
10-minute range, in increments of 1 minute.
If starting or stopping the Dio fails when the Repeat Mode is enabled, the attempt to start/stop
Dio is repeated at the specied repetition interval.
(2) Ao
Sets up the analog value for Ao. You can set up a value within the specified upper and lower
limits, and accuracy.
To Next Page
Loading...
