ROUTING INPUT MODULES
A more detailed explanation of input module routing is described in the next
section of this manual, we will discuss a simplified version now (this makes it
easier to understand other functions being discussed in this section).
Step 1: Press an ARM switch on any desired input module.
Step 2: If you would like this module's CHANnel section routed to track 24,
press the CHAN switch under routing switches labeled (1/2/3..../22/23/24) and
then press the 24 switch.
Now the routing you've made is stored in memory.
Step 3: If you would like this same module's MIX section to be routed to the
stereo mix buss so you could monitor that track, press the black L/R switch in
the mix section right from the tape switch. Now you have two different things
from that input module stored.
You can assign the Aux 5-6 in the same manner. In order to have more aux send
busses, you can route AUX 5-6 to the 24 routing busses.
CHANGING CHANNEL DATA.
In the ARM section of the master module you can assign all module routing
settings by pressing the associated switches. These settings will be stored in real
time.
If new data is entered in the ARM section and you're not pleased press the Undo
switch to restore the old data. The Clear switch will erase all data in that module.
The DATA ENTRY (encoder) knob will allow you to select another module. A
faster method is to hit the ARM switch in the module that needs routing
changes.
BUSS FORMAT
There are two formats to choose from Mono, Multi, or Mono+Multi off
The following assignments can be made;
Mono The Pan-pot is not active on the buss routing
Multi; The buss is in multi format mode meaning that
1,7,13,19 is Left
2,8,14,20 is Center
3,9,15,21 is Right
None The buss is stereo
1=Left, 2=Right, 3=Left, 4=Right etc.
Cinemix manual page: 25
To Next Page
Loading...
