DYNamics
By depressing the Dyn switch S2 you enter the
dynamics menues. It looks like this >
By depressing S1 (Set data) you enter the lower level
of the dynamics menu and it can show like this >
All data related to the selected module can be changed
by pushing S1, S2, S3 or S4. Its related LED lites and the encoder can change
dynamics data. The << and >> switches (left and right from the S1-4 switches)
rolls through all the parameters that can be adjusted by the data wheel.
ESC leaves the Dynamics parameter menu and lets you
move to another module.
PROJECT
All settings related to a project are made in the "Dynamics" display.
S3 (Proj) selects the project. In the project menu you can select a project
number using the DATA ENTRY encoder control.
A maximum of 8 projects can be stored
The S1 (CALL) switch Recalls a project. S4 (save) saves
the project.
LIB
When S4 is pressed the Lib menu appears for dynamics
settings you want to save. The menu looks like this >
There is a maximum capacity for saving of 24 parameter settings. These can be
assigned to individual modules or to all the modules.
Cinemix manual page: 26
Dyn Mod: 23 Mix
Set data Proj Lib
Thr Gt Range Att Rel >
-40dB 10dB 20mS 50mS
CRM: -10dB Dyn Proj: 8
Call Save
CRM: -10dB Dyn Lib 24
Call Save
To Next Page
Loading...
