11. MATRIX SETUP puts the matrix in a programming mode. In this mode
all inputs 1-24 can be individually assigned to one of the matrix outputs (L, C,
R, Sl, Sr, SB) or to no output at all. Programming is done via the SET switch
below the six assign LED's by stepping through all choices.
12. PRESET A and PRESET B is capable of putting the whole matrix in a
preprogrammed mode instantly. Storing of a setup is done by holding down
the PRESET A or B switch by more than 3 seconds.
13. SET is located below the 6 assign LED's and switches between Direct,
Playback and Toggle mode. In Toggle mode the LED of the SET switch is off
and the channel can be switched by the master DIR/PLBK switch.
Any combination of individual switching between direct (DIR) and playback
(PLBK) and master DIR/PLBK switching can be programmed in this way.
The SET switch is also to be used for MATRIX SETUP (see point 12)
14. SOLO puts one input (either Direct or Playback) on Cinemix's Solo buss,
post TRIM control.
15. MUTE cancels the output of a track
16. DIR/PLBK switches all six outputs between direct and playback of all
input channels that are put in TOGGLE mode (SET led in switch is off).
17. MASTER MUTE mutes a whole group of 6 (complete STEMS)
18. TRIM activates the, otherwise fixed, master trim control for an overall
adjustment of the complete 6 track (STEMS) level, when necessary.
Cinemix manual page: 67
To Next Page
Loading...
