Cinemix's CHASSIS SYSTEM
1.0 Cinemix's Chassis
The Cinemix is available in two frame sizes; 32 and 48. The basic frame has one
blank module located on the extreme left of the frame. The three blanks
positioned right from the master section can be replaced by an optional Film
Stems module. This is a module that returns 24 track machine outputs directly
into the CRM summing busses for monitoring pre-recordings.
The blank on the far left side of the frame cannot be replaced with an input
module as they conceal mechanical constructions and internal wiring.
Included with Cinemix's frame are; the master section with associated VU
metering, patchbay, all internal cable harnessing, and rack mount power supply.
Frame 32
The frame 32 will fit 32 dual path mono, 3 optional Stems modules and a
miaximum of 5 dual path stereo modules, the master section, and patchbay.
Frame 32 standard configuration:
From left to right; 24 dual path mono modules, master section, 3 blank modules,
8 dual path mono modules and a maximum of 5 dual path stereo return modules
(10 stereo returns), and pacthbay.
Frame 48
The frame 48 will fit 48 dual path mono, 3 optional stems modules, 3blanks and
5 dual path stereo modules, master section and patchbay.
Frame 48 standard configuration:
From left to right; 32 dual path mono modules, master section, 3 optional stems
modules, 16 dual path mono modules, 5 dual stereo return modules (10 stereo
returns), and patchbay.
Note: Cinemix's patchbay can be ordered on either end of the frame for a small
price increase covering extra mechanical work for re-arranging of internal
mounting of automation and Dynamics PCB's.
Cinemix manual page: 7
To Next Page
Loading...
