Electrical installation
Power connections
High voltage connection
Risk of electric shock.
When you work
with power connections make sure that electricity is disconnected and that the
rotation of the rotor
is prevented.
Mating connectors of the high voltage cables are not part of a standard
delivery.
The order of the phases is marked on the power terminal with stickers.
Figure 36. High voltage connection
1.
Power terminal
Connector type:
AMPHENOL HVBI005R10AMHARD
Mating connector: AMPHENOL HVBI-7-05R10-XFC-XXXX-FG/PC (straight plug)
AMPHENOL HVBI-9-05R10-XFC-XXXX-FG/PC (right angle plug)
Installing the high voltage cables
1. Remove the power terminal
shield. See gure below.
2. Install the high voltage cables. Refer to the instructions of the manufacturer of the mating
connectors.
3. Install the power terminal
shield back.
To Next Page
Loading...
