Conformity according to standards
The electric machine as partly completed machinery is in conformity with the following other
directive(s), harmonized standard(s) or other normative document(s), provided it/they are used in
accordance with our instructions. As partly completed machinery the product itself does not have
declaration of conformity but instead declaration of incorporation. This partly completed
machinery must not be used before the nal machinery into which it is to be incorporated has
been declared in conformity with the Machinery Directive and other relevant directives.
Table 2. Applicable Directives and standards
Standard Explanation
Low Voltage Directive 2006/95/EC
(until 19.4.2016) and
Low Voltage
Directive 2014/35/EC (from
20.4.2016 onwards)
Electrical equipment means any equipment designed for use with a
voltage rating of between 50 and 1000 V for alternating current.
This
electric machine
is
subject to the Low Voltage Directive
2006/95/EC or 2014/35/EC.
Machinery Directive 2006/42/EC
This electric machine is partly subject to the Machinery Directive
2006/42/EC and it is considered as partly completed machinery, as a
part of the nal machinery.
IEC 60034-1:2010 Rotating electrical machines - Part 1: Rating and performance
IEC 60034-5:2001/A1:2007
Rotating electrical machines - Part 5: Degrees of protection provided
by the integral design of rotating electrical machines (IP code) -
Classication
IEC 60034-6:1993 Rotating electrical machines - Part 6: Methods of cooling
IEC 60034-7:1993
Rotating electrical machines - Part 7: Classication of types of
construction, mounting arrangements and connection box position
(IM Code)
IEC 60034-8:2007/A1:2014
Rotating electrical machines - Part 8: Terminal markings and direction
of rotation
IEC 60034-14:2004/A1:2007
Amendment 1 - Rotating electrical machines - Part 14: Mechanical
vibration of certain machines with shaft heights 56 mm and higher -
Measurement, evaluation and limits of vibration severity.
Warranty
Danfoss offers warranty against defects in workmanship and materials for its products for a period
of twelve (12) months from commissioning or eighteen months (18) from delivery (Incoterms-
EXW), whichever occurs rst.
In order for the warranty to be valid, the customer must follow the requirements of this and all
related documents, especially those set out in the product installation and maintenance, as well as
the applicable standards and regulations in force in each country.
Defects arising from the improper or negligent use, operation, and/or installation of the
equipment, non-execution of regular preventive maintenance, as well as defects resulting from
external factors or equipment and components not supplied/recommended by Danfoss, will not
be covered by the warranty.
The warranty will not apply if the customer at its own discretion makes repairs and/or
modications to the equipment without prior written consent from Danfoss.
To Next Page
Loading...
Need help?
General
