Only trained and qualied personnel familiar with the relevant safety requirements are allowed to operate the electric
machine.
Do not use
the electric machine without properly dimensioned and operating cooling system. Maximum operation
temperature, current and rotational speed of the electric machine must not be exceeded to avoid permanent damage.
The surface of the electric machine might be hot.
Do not touch the electric machine during operation.
Entanglement hazard! Do not touch the electric machine
during operation.
Use the anti-condensation heater, if tted, when the electric machine is not in use. This prevents condensation and
possible damage to the electric machine.
Use sufficient personal protective equipment when you are
near the electric machine.
Read the instructions in this
user guide
before you install
the electric machine.
Operation conditions
The electric machine should be used for its intended purpose only and within limits specied by
the manufacturer, concerning:
Loading.
Cooling.
Speed range.
Service interval.
Ambient condition such as temperature and moisture.
The electric machine
is
designed for the following conditions:
Ambient temperature limits:
-40°C...+65°C.
Maximum coolant liquid temperature at the inlet of the coolant circuit, see product data sheet.
Coolant liquid must be water- glycol mixture with maximum of 50 % glycol content. See
Chapter
Recommended coolants.
If electric machine operation limits are exceeded, please contact Danfoss
representative.
To Next Page
Loading...
Need help?
General
