Power failure?
Short-term power failures will not aect your
Danfoss Link system. A power failure lasting
more than 8 hours may result in you having to
reset the date and time, though all other pro-
grammes and units will remain intact.
However, you may nd that the system runs
somewhat “sluggishly” immediately following
a power failure as the network is working hard
to re-establish itself.
One of my room units has been damaged
How does the system react when one of your
room devices is damaged?
When we do not know what the room tempe-
rature is, it is not possible to regulate the oor
heating system. In response, we turn up the
heat, but the system is unable to maintain a
specic room temperature. If a living connect®
radiator thermostat loses its connection to the
Danfoss Link™ CC, it will continue running at
the last known set point.
The Danfoss Link™ CC operating panel will is-
sue an alarm if the room unit has not respond-
ed within 90 minutes. The operating panel will
indicate which device has experienced an error
or in which room the device is missing.
If the device is not physically damaged, you
can start by trying to insert new batteries. If
this does not solve the problem, please con-
tact your installation technician, who can then
remove the defective device from the network
and connect a new one.
^
^
To Next Page
Loading...
