Danfoss Link - Give the System a Little Time to Adapt; Time Temperature

Danfoss Link
General system information
VASUA202link.danfoss.com
If you use the weekly schedule and change the
temperature during a At Home period, then
this may be a general preference for a dierent
temperature. This type of modication will be
permanently saved and will thus become the
new standard At Home temperature for the
room in question.
Please note: This describes the factory settings; your
installer may have set the system up to also
remember modications made locally during
an Away/Asleep period.
^
^
21,0
^
^
21,5
?
21,5˚
Give the system a little time to adapt...
The change is automatically saved in
the Danfoss Link™ system and is now
the new desired temperature for all
At Home periods.
At Home
Customize
Room
The rst week after the system is started up in
weekly schedule, it will take a bit of time for it
to become familiar with its new surroundings.
It is during this rst week that the Danfoss Link
system learns how quickly the dierent rooms
can be heated.
For example, if you set your weekly schedule
to 21 ˚C at 3 pm, the system uses the informa-
tion it has gathered to determine when to be-
gin a reheating cycle as well as how to account
for seasonal temperature dierences.
12:00 17,0 ˚C
12:30 17,0 ˚C
13:00 18,2 ˚C
13:30 19,5 ˚C
14:00 20,5 ˚C
14:30 20,8 ˚C
15:00 21,0 ˚C
Time Temperature
Here you can turn
up the temperature
At Home period