We’re going on holiday; how should we set the system?
It’s quite simple: all you have to do is press the
Vacation key on the initial menu display.
The Vacation function puts the entire house
in hibernation mode, in which all sub-systems
drop to a controlled, low operating point, with-
out the risk of moisture damage, frost damage
or the like.
You can set the Vacation function to start -
and stop at a desired date/time. The system
will automatically return to your preferred set-
tings in advance, so that you return to a com-
fortable warm house.
You can set the Vacation function to apply for
the entire house or to selected rooms only.
If you return home earlier than expected, you
can cancel the Vacation function on the main
screen.
Does the Danfoss Link system have a tamper-proof lock?
Yes. It is possible to use a tamper-proof lock for
the individual room units.
All you have to do is select the Customize
Room on the individual rooms. Next, select
Room Restrictions, which will allow you to set
a maximum and minimum temperature that
can be set from the room in question; alterna-
tively, you can block local room operation all
together. If you have room sensors, you can
also deactivate the heat stop function on the
room sensor.
^
^
21,0
^
^
21,5
Heat stop button
Temperature cannot
be set locally
Pause! I need a break in my schedule ...
If you need to take break from your normal
routine, to air the house for example, then use
the Pause function.
The temperature of the entire system is low-
ered to the safest minimum. You choose if this
is for just one hour or indenitely. To turn o
the Pause function simply turn o the mode.
?
Heating Paused
House control
Turn o the mode now
System is Paused. Turn o the mode
to resume normal operation
To Next Page
Loading...
