Danfoss VLT AAF006 Service Manual

2.2.2 Setting LCP Display Values
The display area is activated when the active filter receives
power from AC line voltage, a DC bus terminal, or an
external 24 V supply
The information displayed on the LCP can be customized
for user application
•
Each display readout has a parameter associated
with it
•
Options are selected in the main menu 0-**
Operation/Display
•
Display 2 has an alternate larger display option
•
The active filter status at the bottom line of the
display is generated automatically and is not
selectable. See 2.3 Status Messages for definitions
and details.
Display Parameter number Default setting
1.1 0-20 Power factor
1.2 0-21 THD of current (%)
1.3 0-22 Line power current (A)
2 0-23 Output current (A)
3 0-24 Line power frequency
(Hz)
Table 2.1
1.1
2
3
1.3
1.2
130BP091.10
0.0%
Off Stop
3 (3)
0°C0.0%
0 A
0 A
Status
Figure 2.2 Default Display Values
2.2.3 Display Menu Keys
Menu keys are used for menu access for parameter setup,
toggling through status display modes during normal
operation, and viewing fault log data.
130BP045.10
Status
Quick
Menu
Main
Menu
Alarm
Log
Figure 2.3
Key Function
Status Press to show operational information.
•
In Auto mode, press and hold to toggle
between status readout displays
•
Press repeatedly to scroll through each
status display.
•
Press and hold [Status] plus [
▲
] or [
▼
] to
adjust the display brightness
•
The symbol in the upper right corner of the
display shows whichsetup is active. This is
not programmable.
Quick Menu Allows access to programming parameters for
initial set-up instructions and many detailed
application instructions.
•
Press to access Q2 Quick Set-up for
sequenced instructions to program the basic
setup
•
Follow the sequence of parameters as
presented for the function set-up
Main Menu Allows access to all programming parameters.
•
Press twice to access top level index.
•
Press once to return to the last location
accessed.
•
Press and hold to enter a parameter
number for direct access to that parameter.
Alarm Log Displays a list of current warnings, the last 10
alarms, and the maintenance log.
•
For details about the active filter before it
entered the alarm mode, select the alarm
number using the navigation keys and press
[OK].
Table 2.2
Operator Interface and Acti... VLT Advanced Active Filter AAF006 D and E Frames Service Manual
2-2 MG90Z122 - VLT
®
is a registered Danfoss trademark
22

Danfoss VLT AAF006 Specifications

General

Brand	Danfoss
Model	VLT AAF006
Category	Water Filtration Systems
Language	English