Danfoss VLT AFE 302 - Electrical Installation, Control Terminals

4.4.4 Electrical Installation, Control
Terminals
To connect the cable to the terminal:
1. Strip insulation of 9-10mm
2.
Insert a screwdriver
1)
in the square hole.
3. Insert the cable in the adjacent circular hole.
4. Remove the screwdriver. The cable is now
mounted to the terminal.
To remove the cable from the terminal:
1.
Insert a screw driver
1)
in the square hole.
2. Pull out the cable.
1)
Max. 0.4 x 2.5mm
130BA150.10
9 - 10 mm
(0.37 in)
1.
130BT312.10
2.
130BT311.10
3.
130BT306.10
How to Install
VLT
®
Active Front End AFE 302 Operating Instructions Liebherr
32 MG.33.X2.02 - VLT
®
is a registered Danfoss trademark
44