3.1.1 Safety Inspection 4-1
3.2 Applying Power to the Adjustable Frequency Drive
4-3
3.3 Basic Operational Programming
4-3
3.3.1 Required Initial Adjustable Frequency Drive Programming 4-3
3.4 PM Motor Set-up in VVCplus
4-4
3.5 Automatic Motor Adaptation
4-5
3.6 Check Motor Rotation
4-6
3.7 Local Control Test
4-6
3.8 System Start-up
4-7
3.9 Acoustic Noise or Vibration
4-7
4 User Interface
5-1
4.1 Local Control Panel
5-1
4.1.1 LCP Layout 5-1
4.1.2 Setting LCP Display Values 5-2
4.1.3 Display Menu Keys 5-2
4.1.4 Navigation Keys 5-3
4.1.5 Operation Keys 5-3
4.2 Backup and Copying Parameter Settings
5-3
4.2.1 Uploading Data to the LCP 5-4
4.2.2 Downloading Data from the LCP 5-4
4.3 Restoring Default Settings
5-4
4.3.1 Recommended Initialization 5-4
4.3.2 Manual Initialization 5-4
5 About Adjustable Frequency Drive Programming
6-1
5.1 Introduction
6-1
5.2 Programming Example
6-1
5.3 Control Terminal Programming Examples
6-3
5.4 International/North American Default Parameter Settings
6-3
5.5 Parameter Menu Structure
6-4
5.5.1 Quick Menu Structure 6-5
5.5.2 Main Menu Structure 6-7
5.6 Remote Programming with MCT 10 Set-up Software
6-11
6 Application Set-up Examples
7-1
6.1 Introduction
7-1
6.2 Application Examples
7-1
7 Status Messages
8-1
Contents
VLT
®
AQUA Drive
Instruction Manual
MG20M922 - VLT
®
is a registered Danfoss trademark
To Next Page
Loading...
